Creating this simple "Pencil Holder"
was fun to create and simple.
Measurements:
Colored Cardstock: 3-1/2" X 5-1/2" Scored on the 3-1/2" side at 1/2", 3/4", 2", and 2-1/4" Rotate to the 5-1/2" side and score at 1/4"
Basic White Cardstock: 2" circle for center image ((scrap pieces are best used for this))
DSP: 1" X 4" ((banner thats between base and circle))
Ribbon/ Twin: Optional approx. 24''
Basic White Cardstock: 1" X 1" ((scrap pieces for sentiment))
Instructions:
To start using your bonefolder fold all the score lines, make them good and flexible. At the bottom of the 1/4" fold. Snip the corner piece off, and then snip each flap. Then use Tear & Tape or Multipurpose glue to run down side of the flap. To assemble fold box over connecting the flap to the inner side. Creating your box. Flip over and assemble bottom of box.
To create the banner. Take your 1" X 4" DSP piece, at bottom using your snips, Snip upward about 1/2", Then from bottom corner snip upward to the center snip, repeat on other side.
No comments:
Post a Comment